![]() However, the results of the monthly and annual tests must still be recorded. Different formats are available to match particular site requirements. If the costs of an engineer’s time and the disruption caused by manual testing are excessive, self-testing emergency lighting should be considered. After the tests, it is recommended that the performance of the system is logged in the fire safety logbook. ![]() However, the test switches could spoil the decor of the building and they must be of a type that is tamper proof. If the emergency luminaires are individually switched, only a single walk around the building will be needed. After restoring the mains supply, the whole building or circuit must be walked again, to check that the emergency lights are recharging. In a system with a single switch for the whole building or a large circuit, after simulating the mains failure it is necessary for the tester to walk the whole building or circuit, to check all emergency luminaire are operating correctly. If manual testing is utilised, the following points should be considered: This test can be carried out manually or automatically.Ī simulated mains failure can be achieved by providing a switch to isolate all lighting circuits / individual circuits / individual luminaires. This will force the emergency lighting system to operate via the battery supply. ![]() To test an emergency lighting system, a mains power failure on the normal lighting circuit / circuits or individual luminaries must be simulated. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |